J-Type Suspension Clamp For Round

Cable(HC-5-8,HC-8-12,HC-10-15,HC-15-20)

Product Description:

J Hook clamps or FTTH suspension clamps, are designed to provide a suspension for 5 to 20mm aerial ADSS cables at intermediate poles on cable routes with angle < 20° on access networks .

with neoprene insert for ADSS cables installed on short spans (100m max)

Key Features:

-Four sizes to cover the full range of ADSS cables from 5 to 20mm..

-Easy install with stainless steel bands or pole bolts.

-The shape of the J Hook allows a running out of the cable directly in the hook

-The suspension clamps can be directly secured to the poles using bolts or bandings. -They can also be installed on hook bolts to provide some flexible suspension point and give extra protection to the cable against wind induced vibrations

-Long service life and low prices.

-

Technical Specification:

Installation procedure

1. Installation of the J Hooks on the poles :

• In case the suspension clamps are directly secured t the pole, place them perpendicularly to the cable route and secure them to the pole using bolts or pole banding. Remove the neoprene inserts.

• In case of suspended J Hooks, install pole brackets or hook bolts at all intermediate poles with angle < 20°. The brackets and/or hook bolts should be positioned on the pole perpendicularly to the cable route.

2. Running out and tensioning of the cable :

• Dead-end the cable at the first end pole.

• The shape of the J HC enables to run out the cable directly in the J Hooks. Some telecom companies however may require the use of temporary running out rollers. Install them just above the J Hook Clamps. Different models of running our rollers are available from Telenco.

• Run the cable on the rollers or directly in the J Hooks to the last end pole and tension the cable to its full installation load using a cable grip, a winch and a dynamometer.

3. Installation of the cable in the J Hooks :